temperature, monitors air temperature, or temperature via a custom sensor, this value can then be used to switch circuits automatically, only allow a circuit to be engaged if within set parameter, or to drop out a circuit if set parameter is exceeded.

rpm / frequency, monitors engine rpm from the alternator taco output, pulses from a suitable senor, or a frequency, to switch loads automatically, engage a load only if within in set parameters, or drop a circuit if it exceeds the set parameters.

volts, monitors battery or mains ( via an adaptor ) voltage, automatically switching circuits based on set parameters, allowing a circuit to be engaged only if within parameters, or drop out a circuit if a set parameter is exceeded.

light, monitors the ambient light level via a remote sensor module, enabling loads to be switched on or off automatically at a preset light level, stop circuits being engaged manually when light level is outside prescribed parameter.

amps, monitor amperage via a electronic shunt, switches loads automatically on or off at a preset level, allows circuits to be switched only when within prescribed parameter, or switched load to be dropped out if current falls out of set parameters.

The list below represents our standard base units, these can normally be configured to suit our customer’s requirement. On receipt of the customers outline specification we can confirm suitability. If outside our standard range, we are happy to quote for a special unit, or modifications to convert a standard one.

Our part number list below represents our base units, and correspond to our price list which covers the cost of configuring a standard unit. Once configured the unit will be issued a unique part number for it’s specification, and future reference.

light sensing control system

amperage sensing control system

temperature sensing control system

rpm / frequency controlled sensing system

voltage sensing control system

311xxxxx

313xxxxx

314xxxxx

315xxxxx

316xxxxx